COMPAS Go: Manual Placement

This article provides detailed information on the new enhancement in the manual layout in COMPAS Go. User can now place the devices in the workbench during configuration as enhancement option in manual layout. Following configurations are enabled with the new changes. Click on the below icon to view the steps for the respective products.


	MCC	Switchboard	LVS	Panelboard

1. Launch the MCC configuration.

2. On doing so, the following is available to the user to configure.

3. After configuring the incoming, branches and options, now the user has option on the configured device to have them placed in the workbench by clicking on the icon

Options available to the user for the instance

	Action	Description
		View configuration in �Read only� mode
		Delete layout for the instance
		Split the instance
		Place the devices in workbench
		Configure the instance
		Duplicate the instance
		Delete the instance
		Check the price of the instance

4. Now navigate to the manual layout tab in the "Layout/Design" as shown below.

5. Now the user can place the device as per the requirement in the layout.

6. If the user is reconfiguring a configuration, it is required to perform the action, "Delete Layout Instance" using the icon or use delete layout from the action menu.

1. Launch the switchboard configuration.

2. On doing so, the user has the following page to configure switchboard

3. After configuring the incoming, main, branch and options, now the user has option on the configured device to have them placed in the workbench by clicking on the icon

4. Now navigate to the Layout/Design and select the manual layout tab as shown below. The devices that were selected to be in workbench are available in the workbench.

5. Now the user can perform manual movement of devices based on requirements by drag and drop or by

6. If reconfiguration is initiated for an existing configuration, user has to perform "Delete layout Instance" as shown below or select the delete layout from the action menu.