|
|
|
How to install a bell alarm on a WL breaker?
1. Remove the trip unit carrier from the breaker.
2. The bell alarm switch mounts on the right side of the carrier as seen from the back with the switch actuator up so the red tripped indicator can press down on it.
3. Secure bell alarm in place using the plastic snap-ins.
4. Feed wires through the wiring slot as shown.
5. Connect the wires to the X9 block by inserting a narrow-bladed screwdriver (3mm) into the rectangular opening and levering gently upwards until the wire can be inserted.
6. Ensure that the order of the wires matches the one shown. This video is meant only to enhance, not replace, the operating instructions enclosed with every product. Please review all instructions carefully before viewing the video. Product instructions are subject to technical changes without prior notice.
