|
|
|
To retrofit to vertical connection (Drawout Breaker) for a WL breaker, the steps are..
1. Remove the laminated contacts on the guide frame.
2. Unscrew the existing connector.
3. Remove horizontal connector.
4. Fit vertical connector.
5. Screw the connector into position. (tighten screws with defined torque)
6. Install the laminated contacts on the guide frame.
This video is meant only to enhance, not replace, the operating instructions enclosed with every product. Please review all instructions carefully before viewing the video. Product instructions are subject to technical changes without prior notice.
This article was:
