Siemens has different family of panel boards which is high level of engineering innovation. They are broadly classified as Lighting panels and Power panels. In COMPAS Go, panel board configuration drives to a specific panel type which is driven by rules from knowledge base. If you want to change it based on you requirement, follow the steps mentioned below.

1. To change the panel type for a line item in a quote, reconfigure the panelboard line item by clicking on wrench icon  as shown below
   
   
   
   Figure 1: Panelboard as line item
    
2. From the above step, it will navigate to the below screen which is the panelboard configuration.
   
   
   
   Figure 2: Panelboard configuration screen
    
3. To navigate to the panel type characteristic, click on modification tab  in the header of the configuration screen. Scroll down until you see panel type. Click the down arrow and select reset.
   
   
   
   Figure 3: Panelboard panel type cstic
    
4. On the selection of new panel type a the message will appear at bottom of screen to confirm the selection. 

          Figure 4: Notification for panel type change

          Click on the delete layout and generate the layout by navigating to the layout tab .

          Figure 5: Delete layout