MCC with embedded Panelboard Configuration

This article describes the advanced version of configurator used for combining the Switchboard or MCC with Panelboard in COMPAS Go.

Nested Configuration can be of the following 

1. MCC - PBD

2. SBD - PBD

1. Login into COMPAS with valid credentials and create a quote/project, click here

2. On successful creation, quote is created. It can be seen as shown below. User can select the ""  or ""for configuration.

Click on the "" to initiate the configuration.

Motor Control Center (MCC)

1. On clicking on the wrench icon, user navigates to the following page.

2. After adding the incoming device, click on the  button.

3. On doing so, the following page is available to the user. click on the panelboard to launch the configuration.

4. Following page is available for the panelboard configuration

5. After completing the "Unit Details", move to the Panelboard tab as shown below and click on the "Launch Panelboard configuration"

6. Following will be displayed for the user. Complete the configuration.

7. After completion, click on the "Add to Main Configuration" from the action menu.

8. Continue with the regular MCC configuration. On completion, go to the "layout/design" view

Action the user can perform.

Following will be displayed to the user

Manual layout view will display the following 

3. On completing the MCC configuration, click on the "Save & Close". The configuration is added as line item.