How to install padlocks on a WL breaker?
How to install padlocks on a WL breaker? 1. Slide locking bracket into position. 2. Latch plate of locking bracket in control gate. 3. Tighten the screws on the...
Comments: 0
How to install rated current coding for a WL breaker?
How to install rated current coding for a WL breaker? The rated current is coded at the factory, i.e. each and every circuit breaker can only be inserted into a cradle...
Comments: 0
How to install safety locks for a WL breaker?
How to install safety locks for a WL breaker? 1. Fit the driver disc into the control gate. 2. Insert the nut to the left of the driver disc. 3. Attach lock to...
Comments: 0
How to install the BSS for a WL breaker?
How to install the BSS for a WL breaker? 1. Remove the trip unit from the breaker, disconnecting all the wiring from the secondary disconnect blocks. 2. Remove the...
Comments: 0
How to install the current sensor for a WL breaker?
How to install the current sensor for a WL breaker? 1. Insert CT. 2. Establish plug-in connection. 3. Insert cover of cable duct and secure it. 4. Screw CT...
Comments: 0
How to install the front panel on a WL breaker?
How to install the front panel on a WL breaker? 1. Adjust the spring charging level to allow the front panel to slide on. 2. Slide on & attach front panel. 3....
Comments: 0
How to install the mechanism operated contacts (MOC) clutch for a WL breaker?
How to install the mechanism operated contacts (MOC) clutch for a WL breaker? 1. Snap the clutch into place, through the opening in the right side of the breaker. ...
Comments: 0
How to install the rear vertical bus connectors for a WL breaker?
How to install the rear vertical bus connectors for a WL breaker? 1. Place the vertical connector underneath the primary bus stab of the breaker. 2. Insert the...
Comments: 0
How to locate the Breaker ID and Catalog Number for a WL breaker?
How to locate the Breaker ID and Catalog Number for a WL breaker? 1. The breaker catalog number and ID are found at the bottom of the ratings label in the upper right...
Comments: 0
How do you lubricate the cradle for a WL breaker?
How to lubricate the cradle for a WL breaker? 1. Pull the cradle rails out of the cradle. 2. Wipe the sliding surfaces with a clean cloth. 3. Apply a small amount...
Comments: 0