Getting Error after configuring a Power Mod: Config instance configuration is not completed/conflicted. Do you want to add the configuration?
This happens when a required field has no entry. Required fields are the fields that labeled with blue lettering and have a blue asterisk behind it:
Comments: 0
How to get the SPD catalog number on a Switchgear configuration
Go to your aux compartment that you checked SPD under the Surge Limitation tab. Select the SPD tab and find the catalog number field
Comments: 0
How to add Digital Meter in Panelboard?
This article provides information on how to add digital meter in Panelboard in COMPAS Go. 1. Add Custom Meter from Devices Tab. Select Digital Metering. 2....
Comments: 0
How to change circuits in P2 Panelboard?
This article helps user to reset the circuit type for panelboard configuration. 1. Complete the Panel board configuration which drives to a specific Panel type...
Comments: 0
How to edit the section properties in a Switchboard configuration?
The manual layout view provides users the ability to access a section properties to clear section, move section and edit depth. 1. Click and open the manual layout in...
Comments: 0
How to add Alt Gauge Boxes for P1 thru P5
Alternate Gauge Boxes available for P1 thru P3 and Not available for P4, P5. 1. Alt Gauge available 10 Gauge or 12 Gauge only needs to be added as a special...
Comments: 0
How to add Key Interlocks on Panelboards
Key Interlocks are not available in P1 thru P3, They are available in P4 and P5 only. 1. Key Interlocks needs to be added as a special mod. 2. Select...
Comments: 0
How to add Piano Hinges for Panelboards
Piano Hinge trims are available for P1 thru P3 only option not available for P4 and P5 Piano Hinges needs to be added as a special mod. Select special mod at...
Comments: 0
How to add Stainless trims?
Yes they are available for P1 thru P3 in Nema 1 trims only. Stainless Trim or Door not available in P4 and P5. 1. Trim needs to be added as a special mod. 2....
Comments: 0
How to create a non-bussed pull section in Switchboard?
Editing of section properties after layout generation is possible in COMPAS Go. 1. In COMPAS Go select the layout/design and add section button. 2. After...
Comments: 0