What is the smart selector option for Nema Starter?
This article describes the enhancement feature in the product selector for NEMA starter. Selector helps you to select the correct part number by selection of...
Views: 12500
Comments: 0
How do you set breaker trip unit type to solid state in Panelboard?
Siemens has different family of panel boards which is high level of engineering innovation. They are broadly classified as Lighting panels and Power panels. In COMPAS...
Views: 12452
Comments: 0
The difference between Hot and Cold utility metering
Understanding the difference when selecting between hot and cold metering You must select "hot" or "cold" metering when adding a utility meter to a switchboard. Hot...
Views: 16954
Comments: 0
Adding Subfeed Breaker in Panelboard
How to confirm you have added a sub-feed breaker into a panelboard? After launching the panelboard, the following screen is available to the user Add the branch...
Views: 12747
Comments: 0
How to add tenant breaker to PowerMod meter stack?
This article describes how to add a tenant circuit breaker to PowerMod meter stacks 1. On the product selector page, scroll down until you locate the "Multi-Family...
Views: 12541
Comments: 0
Panelboards application in seismic zone
This article describes the panelboard configuration for seismic zone. In the configuration, Go to Panel tab. Navigate to the Paint tab as shown below. Select...
Views: 12547
Comments: 0
How to add Endwall with Knockouts in Panelboard?
This article helps user to select the Endwall with Knockouts in the panelboard configuration. 1. Launch panelboard configuration or reconfigure an existing...
Views: 12427
Comments: 0
How to add double lug or sub feed lugs in Panelboard in COMPAS Go?
This article helps user with information to add Sub Feed Lugs option to panelboard configuration. 1. Launch a new configuration of panelboard or reconfigure an...
Views: 12607
Comments: 0
How to add 750MCM MLO for P2, P3
MLO with 750MCM needs to have additional 6" of end Gutter Space for proper wire bending space 1. Select the 750MCM lugs 2. Select 6" additional end gutter...
Views: 12425
Comments: 0
How to configure a Column Panel in COMPAS Go.
Start a new Panelboard configuration. On the "Panel" main page, scroll down to Classification. Select Column Type. Continue configuration with Main, Devices and...
Views: 12570
Comments: 0