The Skinny Main box is not available for the 1600A WL. What should I do?
This article provides detailed information on skinny main in COMPAS Go. The 25W WL section and HD combo sections are driven by the WL frame size selection. FS1 will...
Comments: 0
How do I input rear load barriers into switchboard section?
This article provides detailed information on rear load barriers (rear bus barriers) into switchboard section in COMPAS Go. 1. After completing the switchboard...
Comments: 0
SEM3 Networking Detail
SEM3 Networking Detail The following information is detailed networking information for the SEM3 Controller. Default SEM3 Controller networking settings IP Address ...
Comments: 0
How to configure 150A and 250A Frame 3VA Breakers to P2 and P3 Panels?
This article describes the configuration of configure 150A and 250A Frame 3VA Breakers to P2 and P3 Panels. 1. Login into COMPAS with valid...
Comments: 0
COMPAS Go: Service Configurator - FAQ
This article consolidates all the answers to your questions on electrical service configurator in COMPAS Go. [click on the "Expand All" button to view the answers...
Comments: 0
COMPAS Go : Service Configurator for Sales and Channel partners
This article describes the detailed steps to add electrical service line items for the configurations in the sales quote [service configurator for sales and channel...
Comments: 0
MBK Kit questions
This article provides information on the MBK Kits and revised P1 changes for 3VA 400A and 3VA41. Immediate change in 1" Filler - DFFP1 changing to DFFP1A RP1...
Comments: 0
How to use conflict resolution while configuring Panelboard product?
This article is to guide users to use conflict resolution while configuring Panelboard product. [resolve conflicts] 1. In configuration conflict is indicated with RED...
Comments: 0
How to change Panelboard configuration mode in COMPAS Go?
This article describes the steps to change configuration mode for panelboard and enable the user to use the basic configuration. Changing the configuration mode is a...
Comments: 0
How to use drawing preference in COMPAS Go?
This article provided information on the setting the drawing preference in COMPAS Go. 1. Click on the setting as shown below from the task menu. [] 2. On doing...
Comments: 0