Sandy FAQ

Configuration
How to add Special or Custom Locks to Panelboard?
This article helps user to select the locks in the panelboard configuration. 1. Launch panelboard configuration or reconfigure an existing configuration. On doing so,...
Views: 13073 Comments: 0
How to add Gutter Device like Toggle Switch, Pilot Light, Push Button in Panelboard?
This article helps user with information to add gutter devices to panelboard configuration. 1. Launch a new configuration of panelboard or reconfigure an existing...
Views: 13024 Comments: 0
How to add Endwall with Knockouts in Panelboard?
This article helps user to select the Endwall with Knockouts in the panelboard configuration. 1. Launch panelboard configuration or reconfigure an existing...
Views: 12985 Comments: 0
How to add double lug or sub feed lugs in Panelboard in COMPAS Go?
This article helps user with information to add Sub Feed Lugs option to panelboard configuration. 1. Launch a new configuration of panelboard or reconfigure an...
Views: 13161 Comments: 0
Panelboards application in seismic zone
This article describes the panelboard configuration for seismic zone. In the configuration, Go to Panel tab. Navigate to the Paint tab as shown below. Select...
Views: 13113 Comments: 0
How to configure a Column Panel in COMPAS Go.
Start a new Panelboard configuration. On the "Panel" main page, scroll down to Classification. Select Column Type. Continue configuration with Main, Devices and...
Views: 13128 Comments: 0
How to view drawing during Panelboard configuration in COMPAS Go?
This article helps user to enable the option of viewing the drawing report during configuration of panelboard in COMPAS Go. 1. Complete the panel configuration and...
Views: 13011 Comments: 0
Submitting a Manual Line Item for Technical Review
Quoted catalog number with pricing, is required to be attached to the quote when submitting a manual line item for technical review. 1. Create a valid quote and...
Views: 13056 Comments: 0
Why was my quote line rejected for technical review?
1. Did you attach any required documentation needed to approve the quote? 2. Did you select the correct shipping location for a manual line item? 3. Did you...
Views: 13088 Comments: 0
Where to see the lead time for a configuration?
There are multiple places to view the lead-time of a configuration; here are the two most common places. 1. View the lead-time at the top right of the configuration....
Views: 13197 Comments: 0

← Prev 10 / 25 Next →
... 5 6 7 8 9 10 11 12 13 14 ...(Page 10 of 25)