How to add Gutter Device like Toggle Switch, Pilot Light, Push Button in Panelboard?
This article helps user with information to add gutter devices to panelboard configuration. 1. Launch a new configuration of panelboard or reconfigure an existing...
Views: 11323
Comments: 0
How to add Special or Custom Locks to Panelboard?
This article helps user to select the locks in the panelboard configuration. 1. Launch panelboard configuration or reconfigure an existing configuration. On doing so,...
Views: 11349
Comments: 0
How to configure a B Phase High Leg or C Phase High Leg panels?
This article helps to configure B Phase High Leg or C Phase High Leg panels. For B Phase High Leg: Select System Voltage = 240/120 3Ø 4W DELTA BØ H L AC For C...
Views: 10944
Comments: 0
Generator Ready Switchboards
How to configure a Generator Ready Switchboard. Please Click Here.
Views: 11709
Comments: 0
How to add Alt Gauge Boxes for P1 thru P5
Alternate Gauge Boxes available for P1 thru P3 and Not available for P4, P5. 1. Alt Gauge available 10 Gauge or 12 Gauge only needs to be added as a special...
Views: 11291
Comments: 0
How to add Piano Hinges for Panelboards
Piano Hinge trims are available for P1 thru P3 only option not available for P4 and P5 Piano Hinges needs to be added as a special mod. Select special mod at...
Views: 11328
Comments: 0
How to add Stainless trims?
Yes they are available for P1 thru P3 in Nema 1 trims only. Stainless Trim or Door not available in P4 and P5. 1. Trim needs to be added as a special mod. 2....
Views: 11391
Comments: 0
How to create a non-bussed pull section in Switchboard?
Editing of section properties after layout generation is possible in COMPAS Go. 1. In COMPAS Go select the layout/design and add section button. 2. After...
Views: 11459
Comments: 0
Switchboard Series Ratings
COMPAS Go has the latest valid series ratings programmed. The series ratings are documented on pages 7-212 – 7-222 of SPEEDFAX. Select "Series Rated" at the...
Views: 11005
Comments: 0
When to use Tapered Bus vs. Non-Tapered Bus in switchboard configuration in COMPAS Go?
This article describes the usage of Tapered Bus vs. Non-Tapered Bus in switchboard configuration. Used when value engineering a job that allows for Tapered bus. ...
Views: 12172
Comments: 0