How to configure IR (Infrared) Viewing Window in Switchboards
This article provides information to configure the Infrared viewing window(s) during configuring the Switchboard. Specifications may call for a Infrared viewing window(s) to view Lug connections...
Views: 12537
Comments: 0
How to configure a MCC Unit in COMPAS Go?
Motor Control Centers may require a new device to fit into an existing space. Users can configure the MCC Unit in COMPAS Go After creating a project and click on...
Views: 12069
Comments: 0
How to use configuration conflict resolution?
User guide on how to use conflict resolution while configuring a product. 1. In configuration conflict is indicated with RED indicator (as shown in picture below) ...
Views: 11907
Comments: 0
How to use Manual Placement
Article describing how to perform manual placement/ rearrangement of configuration layout for Switchboard, MCC, etc. Step-by-step guide Configure a product e.g. MCC (Motor Control Center) and...
Views: 11815
Comments: 0
How do I configure a Safety Switch?
Safety Switch is a fusible device. Safety switches are built for specific voltages and amperage"s. Step-by-step guide Safety switch configuration. Start at the Add Products view. ...
Views: 11950
Comments: 0
How to configure a Safety Switch (Video)
Need help in getting the catalog number and adding it to the proposal? Click on the below link to review this training Your browser doesn"t support video. ...
Views: 11775
Comments: 0
How do you add engineering notes
Article describing steps for adding engineering notes to Switchboard drawing / layout Step-by-step guide Go to a existing job or start a new job using COMPAS GO. Using Add Product action...
Views: 11782
Comments: 0
How to add Enclosed Breaker in COMPAS Go
To add Sentron or 3VA Enclosed breaker to a quote follow below steps Step-by-step guide Go to quote page Select Add product Select + icon of Circuit Breaker to show list of options ...
Views: 11913
Comments: 0
How to Add Ground Bar to Starter
How to Add Ground Bar to Combination Starter Step-by-step guide Configure your starter under mods choose Z1 (See Attached) Go back to your Siemens products screen and select the Starter...
Views: 11795
Comments: 0
How to add SPD to Panelboard
Step-by-step guide Got to an existing job or start a new job. If you are adding a SPD to an existing line, open the line, do Delete Layout first before marking any changes to the panel,...
Views: 12239
Comments: 0